1. The main pole of the lamppost should be galvanized square tube with a wall thickness of 3.5mm. and light source power: LED30W.

2, the part of the whole full welding welding, the welding quality is uniform and firm, to meet the requirements of GB/T12469, without affecting the strength of the crack, slag, welding, wear, arc pit, no defects such as folds and interrupt.

The allowable deviation of 3, the lamp shall comply with the following specifications: length of the rod length of allowable deviation is + 0.5%; the straightness error should allow the shaft less than 1%; the shaft cross section diameter, diagonal or margin allowable deviation should be + 1%; the lamp arm elevation allowable deviation should be + 1%.

4, the anti-corrosion (including rod, flange, rib plate, pole gate, lighting installation joints) by surface galvanizing after spray treatment, corrosion quality consistent with the provisions of GB/T9790, which (inside and outside) of the hot dip galvanizing layer average thickness of not less than 85 m, the quality of outdoor lamp with pure polyester plastic powder, average the thickness of more than 100 m, with uniform and complete and smooth surface, the adhesion to meet the requirements of the relevant standards.

The access door and pole axis, 5 pole parallel to the ground below, 400mm opened 320mm * 120mm access door to door door hole welding terminal; and the door cover edge is smooth, the door cover and the hole of the door and the door after the assembly clearance is not greater than 2mm, the door cover is interchangeable, and has security measures reliable.

6. All the fasteners except the base are made of 304 stainless steel. All fasteners must be provided with relaxation measures.

7, the lamp holder material is die-casting aluminum, without light source, empty bag weight 8KG-9KG.

8, wind resistance rating: 12.

Solar system components

1. Solar panel module: 100W.

The polycrystalline silicon solar panel, Italy Cummins imported TPT EVA domestic solar energy solar component aluminum frame, the conversion rate 16.2 above, more than 20 years of life.

2 batteries: 100AH/12V.

Solar energy free maintenance battery, the discharge depth of up to 80%, the service life of more than 6 years, to adapt to the environmental temperature range of -20 degrees, /+65 degrees.

3 、 controller: 12V/10A.

With light control + time and space, there are overcharge, over discharge, anti reverse, short circuit, lightning protection functions, etc., can set up a variety of working mode, the service life of more than 5 years.

Buried box: 1PCS.